Power, Keyboard, And Mouse; Graphics Cards - HP c8000 Hardware And Software Setup Manual

Hardware Setup

Power, Keyboard, and Mouse

Å

Graphics Cards

1–4
To connect the power, keyboard, and mouse:
1. Connect the power cords to the rear of the monitor and the
computer.
2. Connect both power cords to a grounded outlet, for tower
systems, or to a power distribution unit (PDU) on the rack, for
racked systems.
3. Plug the keyboard and mouse into the USB ports on the back of
the system.
WARNING: For your safety always connect equipment to a grounded wall
outlet. Always use a power cord with a properly grounded plug, such as the
one provided with the equipment, or one in compliance with national safety
standards. Locate the equipment close to an easily accessible power outlet to
ensure that the equipment can be unplugged quickly, if necessary.
The c8000 workstation is available with a range of graphics cards.
Graphics cards may include a 15-pin connector, an 18-pin
connector, or both. Only one connecting cable is needed for each
monitor.
If your workstation did not ship with a pre-installed graphics
card, you must install the card and load the drivers. Refer to the
documentation included with your graphics card for instructions.
Vertical refresh frequencies of 85Hz and higher provide
flicker-free viewing.
The graphics card automatically limits itself to resolutions and
frequencies supported by DDC-2B or DDC-2B+ compliant
monitors.
For a complete and current list of supported cards with supported
display resolutions and frequencies, see:
http://partsurfer.hp.com
HP workstation c8000 — Getting Started