Software Setup
Starting the System
2–2
The first time you start the system, the software is initialized as
explained on page 2-3.
To start your system:
1. Turn on the monitor before you start your system.
2. Press the power button on the front panel. The system starts.
During system startup, the display may remain blank for up to
one minute. This is normal. The following should occur:
a. System status LED on the front panel turns on and blinks
green.
b. Diagnostic LEDs 1-4 on the rear panel create a scrolling
pattern.
3. If you are prompted for a password, type it and press
HP workstation c8000 — Getting Started
.
Enter