Table of Contents
Advertisement
Installing and Connecting the HP 600/610 External Power Supplies
Installation Procedures
1. Prepare the Installation Site
2. Mount the Unit
The HP 600 RPS/EPS and HP 610 EPS can be mounted in these ways:
Rack or Cabinet Mounting
The HP 600 RPS/EPS and HP 610 EPS are designed to be mounted in any EIA-
standard 19-inch telco rack or communication equipment cabinet. The
mounting brackets have multiple mounting holes and can be rotated allowing
for a wide variety of mounting options.
W A R N I N G
For safe operation, please read the mounting precautions on
page
E q u i p m e n t
The 12-24 screws supplied with the unit are the correct threading for standard
C a b i n e t
EIA/TIA open 19-inch racks. If you are installing the unit in an equipment
cabinet such as a server cabinet, use the clips and screws that came with the
N o t e
cabinet in place of the 12-24 screws that are supplied with the unit.
1.
2-6
Cabling - Only use the EPS cables supplied with the unit for external
power connections to switches. Only use the EPS backup power cables
supplied with the HP 610 EPS to connect to other HP 610 EPS units in the
backup power group. Only use the RPS cables supplied with the
HP 600 RPS/EPS for redundant power connections to switches.
Installation Location - Before installing the unit, plan its location and
orientation relative to other devices and equipment:
•
In both the front and back of the unit, leave at least 7.6 cm (3 inches)
of space for the EPS and RPS cables, EPS backup power cables, and
the power cord.
•
On the sides of the unit, leave at least 7.6 cm (3 inches) for cooling.
in a rack or cabinet
on a horizontal surface
2-4, before mounting the unit.
Use a #1 Phillips (cross-head) screwdriver and attach the mounting
brackets to the unit with the included 8-mm M4 screws. The screws must
be tightened sufficiently to provide proper support for the unit in the rack.
Hide quick links:
Advertisement
Table of Contents
