Front Of The Unit; Eps Ports On The Hp 610 Eps; Leds - HP ProCurve J8161A Installation And Getting Started Manual

Front of the Unit

Power
and Fault

LEDs

EPS port LEDs
EPS Port Status
Device Connected E2 E1
Power Status
Fan/Temp
Power
Status
Fan/Temp Status flash = Temperature too high
Fault
Fan/Temp Status + Fault flash = Fan failure
Fan/Temp Power Status
Status LED
Power
and Fault
LEDs
EPS Backup Power port LEDs
HP ProCurve
610 EPS
J8169A
EPS Backup Power Ports Status
Power
Internal Power Status
In Ready Out Ready
Fan/Temp Status
Fault
Fan/Temp Status flash = Temperature too high
Fan/Temp Status + Fault flash = Fan failure
Internal Power
Fan/Temp
Status LED
Status LED

EPS Ports on the HP 610 EPS

The HP 610 EPS has four external power supply ports. You can connect one
to four HP PoE capable switches to provide PoE power as a primary or backup
source. Power is equally shared between the EPS ports in pair A (that is, port
A1 and A2) and between the EPS ports in pair B (port B1 and B2); one port in
each pair supplies maximum power (408 W) if the other port is not used.
LEDs
Table 1-1.
LED State
Power On
(green)
Off
Introducing the HP ProCurve 600/610 External Power Supplies
RPS port LEDs
RPS Port Status
R6 R5
Device Connected R4
Power Status
Device Connected
EPS Ports Pair A
(408 W total for PoE applications)
A1
EPS A1 EPS A2
Power Status
EPS Pair A
HP 600 RPS/EPS and HP 610 EPS LEDs
Meaning
The unit is powered on.
The unit is NOT powered on.
R3 R2 R1
Power Status
EPS port LEDs
EPS Ports Pair B
(408 W total for PoE applications)
Device
A2 B1
Connected
EPS B1
Power
Status
EPS Ports: 50 V
8.3 A max per port pair.
Device Connected
Front of the Unit
HP 600 RPS/EPS
HP 610 EPS
Device
B2
Connected
EPS B2
Power
Status
EPS Pair B
1-3