Philips AVENT SCD630/37 Troubleshooting Manual page 2

monitor. Try a different location or decrease the distance between the baby unit and parent unit.
It can take up to 10 seconds before the connection between the units is reestablished.
Note: If the signal is lost, the parent unit will beep three times every 20 seconds.
Units are too close to each other
Make sure that the baby unit and parent unit of your Philips Avent Baby monitor are at least 1.5
meters / 5 feet away from each other to prevent interference.
Other devices are interfering the connection
The connection between the parent unit and baby unit of your Philips Avent Baby monitor runs
on a wireless connection. The units of your Philips Avent Baby monitor may be too close to
other devices that are interfering on the same frequency (e.g. smartphones, tablets, laptops,
DECT phones or even microwaves). Try out different locations or turn off other devices and test
again.
A software error occured
You can reset the parent unit of your Philips Avent Video baby monitor by simultaneously
pressing the power button and the navigation down button for 1 second. The parent unit will
turn off automatically after 1 second. In order to turn the Philips Avent Video baby monitor on,
press the power button again.
Contact us for further assistance if the issue persists.
The information on this page applies to the following models: SCD630/37 , SCD501/10 ,
SCD560/10 , SCD570/10 , SCD535/00 , SCD525/00 , SCD510/00 , SCD530/00 , SCD520/00 ,
SCD589/54 , SCD590/54 .