In Case Of An Abnormal Movement; Reset The System - Seiko C-20 Instructions Manual

At trouble
The watch displays an
Misalignment
incorrect time hour unit,
of the time
even though it displays the The time zone selection is incorrect.
and hand
precise time of minutes
positions
and seconds.
The date is out of the preliminary
The reception results are
position.
successful and the precise
Misalignment This happens when the date is out of
time is displayed, but the
of the date the preliminary position as a result of
date is not correctly
influence of various external sources or
displayed.
after the built-in IC is reset.
The stopwatch hands are out of the
Misalignme After resetting the preliminary position.
nt of the stopwatch, the stopwatch This happens when the stopwatch
stopwatch hands do not stop at the 0- hands are out of the preliminary
hands second position. position as a result of external influence
or system reset.
Time zone Time zone cannot be set. The stopwatch hands are moving.
8
100
EN

In case of an abnormal movement

In the case that the watch moves abnormally or that the watch does not move at one-second intervals even
after fully charging the battery, then it can be returned to normal operation using the following operation.

■ Reset the system

1
Pull out the crown to the second click.
The small seconds hand moves to the 0-second
position and stops.
* The date and stopwatch hands also stop.
* When the crown is a screw lock type, unlock it.
→ P.15
8
102
EN
Possible causes Solutions
Check the selected time zone and set it
to the area where the watch is used.
Set the date to the preliminary position
"1" (the 1st).
Adjust the preliminary position of the
stopwatch hands to "0."
Reset the stopwatch before setting the
time zone.
Pull out the
0-second crown to the
position second click
Reference At trouble
The crown or button
P.32 Operation
cannot be operated.
P.87
You get lost in the middle
Operation
of the operation.
P.91
Blur on the dial glass
Others
persists.
P.40
* For the solution of troubles other than the above, consult the retailer from whom the watch was purchased.
2
Press and hold Button C and Button D
simultaneously for three seconds, and
then release them.
In five seconds after releasing the buttons, the small
seconds hand makes a full rotation and stops at the
0-second position.
Then the hour and minute hands will start to move
and stop pointing to 12 o'clock 0 minutes.
* The 24-hour hand moves accordingly with the hour
and minute hands, and stops at the 0-hour position.
* The stopwatch second hand moves, and then stops
at an arbitrary position.
* The button cannot be operated until all the hands stop.
0 1 2
Possible causes Solutions
The stored electric power is running Keep charging until the small seconds
short. hand is moving every second.
Hands and date are moving right after Wait without doing anything.
a setting is carried out by the crown or After the date stops, the crown and
button operation. button can be operated.
Return to the status before the start of
the operation, and try the operation
again.
If the crown is pulled out, push it in.
-----------
If the crown is not pulled out, then pull it
out and push it in again.
This will return to one-second interval
movement for a maximum of 9 minutes.
After this, try the operation again.
A small amount of water has got inside
Contact the retailer from whom the
the watch due to deterioration of the
watch was purchased.
gasket, etc.
Reference
P.48
-
-
-
8
101
EN
Press
Button C for
3 seconds
Press
Button D for
3 seconds
8
103
EN