Condition
The reception results
are successful and the
Misalignment
precise time is displayed,
Set the date to the preliminary position 1 (the 1st).
of the date
but the date is not
correctly displayed.
The reception result display
confirms successful
Misalignment
Check if the day is set to the correct preliminary position S
reception, and the correct
of the day
(Sunday). If not, correct the preliminary position for day.
time is displayed, but the
wrong day is displayed.
Wrong
The sub dial is set to the time
display of
shown by the main watch, but the
Refer to How to set the sub dial .
the sub dial
sub dial displays the wrong time.
Sufficiently charge the watch until it starts moving at one-second intervals.
The crown or buttons
When the date hand is moving right after a setting is carried out by a crown or
cannot be operated.
button operation, after the date stops, the crown and buttons can be operated.
Operation
You get lost in
1. If the crown is pulled out, push it back in.
7
the middle of the
2. T he watch will resume its normal one-second interval movements within 9 minutes.
operation.
3. Start the setting procedure from the beginning.
Others Blur on the dial glass persists. Contact the retailer from whom the watch was purchased.
※ For the solution of troubles other than the above, consult the retailer from whom the watch was purchased.
142
Specifications
1. Basic feature ・ ・・・・・・・・・・・・・・・・ Basic watch with three hands (hour, minute and second hands), date display,
Retrograde day indicator, Sub dial with 2 hands (Hour and Minute hands)
2. Frequency of crystal oscillator ・ ・・ 32,768 Hz (Hz = Hertz ... Cycles per second)
3. Loss/gain (monthly rate) ・ ・・・・ Loss / gain ±15 seconds on a monthly rate (Except the case when the watch is
used without an automatic time setting by receiving a radio signal and when it is
worn on the wrist within a normal temperature range between 5℃ and 35℃).
4. Operational temperature range ・ ・・ Between −10℃ and +60℃
5. Driving systems ・ ・・・・・・・・・・・・・ Step motor (Hour and minute hands, second hand, and the date, day and hour and
minute hands for sub dial)
6. Power source ・・・・・・・・・・・・・・・・ Secondary battery, 1 piece
7. Duration of operation ・ ・・・・・・・・ Approximately nine months (Fully charged, and the Power Save is not activated).
※ I f the Power Save is activated after it is fully charged, the watch continues to
run for approximately two years at maximum.
8. Time setting by receiving
・・・・ Automatic reception (before 2:00 AM, 3:00 AM and 4:00 AM)
the JJY-LF radio signal
※ Reception attempts depend on the radio signal receiving conditions.
※ A fter having received a radio signal, the watch will start to move depending on
the quartz movement until the next reception.
※ Manual reception is also available.
9. IC (Integrated Circuit) ・ ・・・・・・・ Oscillator, frequency divider and driving circuit C-MOS-IC, 3 pieces
8
※ The specifications are subject to change without prior notice for product improvement.
144
Reference
Solutions
pages
P.135
P.135
P.96
P.108
−
−
In case of an abnormal movement
In the case that the watch moves abnormally or that the watch does not move at one-second intervals
even after fully charging the battery, perform the procedures from 1. to 3. and then set the preliminary
positions and select the time zone.
1. Pull out the crown to the second click.
■ How to reset the built-in IC
Button A
2. Keep pressing down the Button A and B at the
2. Press for
3 seconds
1.
0 1 2
3.
3. When all the hands stop pointing to 12 oʼclock
Button B
2. Press for
3 seconds
※ Unlock the crown before operating it and then,
※ After the built-in IC is reset, the watch is set to the time zone LON.
relock it after completing the operation. → P.85
After completion of a system reset, perform the following operations.
(NOTE) F irst, press the Button B, and subsequently
press the Button A while holding down the But-
・ How to correct the preliminary positions → P.135 - 138
ton B so as to press both of them successfully.
・ How to select the time zone → P.90 - 91
全国共通フ リ ーダイ ヤル
お客様相談室
〒 100-0005 東京都千代田区丸の内 3-1-1 国際ビル
〒 550-0013 大阪市西区新町 1-4-24 大阪四ツ橋新町ビルディ ング
http://www.seiko-watch.co.jp/
The second hand stops at the 0-second position.
same time for 3 seconds, and then release them.
Within 5 seconds after releasing the buttons, the second
hand makes a full rotation and stops pointing to the 0-second
position. Then the hour and minute hands will start to move
(NOTE)
and stop pointing to 12 oʼclock 0 minutes.
0 minutes and 0 seconds, push the crown back.
The second hand starts moving from 12 oʼclock
0 minutes and 0 seconds.
0120-612-911
7
143