In Case Of An Abnormal Movement (Resetting The Built-In Ic) - Seiko Astron GPS SBXA038-1 Basic Manual

6
TROUBLESHOOTING
Continue to press Button A
Press Button B or C
4 5 (2 seconds) and release it
to adjust the indicator
when the second hand
hand as shown in the
moves to the 0-second
fi gure
position.
Adjust the indicator hand The watch enters the
to the position as shown mode to adjust the
in the fi gure. preliminary position of the
hour/minute hands.
※ If the indicator hand points
as shown in the fi gure, go
※ It the watch displays
to operation of ⑤ .
the precise time, go to
operation of ⑦ .
To move
the hand
Press
clockwise
for
2 sec
To move the
hand counter-
clockwise
If the button is kept pressed
for 2 seconds or longer, the
hand will move continuously.
Press the button again to
stop the hand.
※The indicator hand makes
one complete turn, but this
does not mean a failure.
※ If no operation is performed for more than 1 minute or when Button A is pressed once, the watch returns to the time display mode.
When the watch has returned to the time display mode, restart operation.
W h e n o p e r a t i o n i s
6 7
Press Button B once c o m p l e t e d , p r e s s
and then release it Button A and release
it
The hour/minute hands The mode to adjust the
move, and stop at 00:00 preliminary position is
am. completed, and the second
hand and the hour/minute
hands start moving.
Press Press
56
6
TROUBLESHOOTING
In case of an abnormal movement (resetting the built-in IC)
In the case that the watch Reset the system ( ② 〜 ④ )
moves abnormally or that
the watch does not move at
1-sec intervals even after
2
fully charging the battery,
Pull out the crown
perform the procedures from
to the second click
① to ⑨ to re-establish normal
function.
The watch can be recovered
The second hand stops at
to the initial state by the
the 13-sec position.
system reset when trouble
occurs. ( ② 〜 ④ )
A f t e r t h a t , a d j u s t t h e
preliminary position of the
date and indicator hand ( ⑤
〜 ⑨ ) and set the time ( ⑩ )
before use.
0 1 2
1
Pull out
Unlock the crown the crown
to the
second click
Unlock the crown
Unscrew
Continue to press Button
When the hands stop
3 4
A and C simultaneously
at 00:00:00, push
for 2 sec, and then release
the crown back in
them
The second hand moves
When the buttons are
from 00:00:00.
released, the second
hand makes one
complete turn, and stops
at the 0-sec position.
After that, the hour/ Push
back
minute hands move and
stops at 00:00.
0 1 2
Press
for
2 sec
※ L ock the
crown.
While pressing the crown in
Press
for
2 sec
Screw
※ A fter the system reset,
the time zone is set to
UTC/LON.
57
Continued on the following page
in