Seiko Alarm Chrono 7T32 Setting Instructions

Download this manual

Seiko Alarm Chrono

Cal. 7T32 - Setting Instructions

Created 05-07-2001

Refer to the instructions below for directions on how to set this watch

Note: your watch may have a different case or face than the one shown in the pictures.

The important thing is that they all share the same basic movement.

All Reset

All reset is used when first setting the watch or when there is unusual or erratic operation.

A - Pull Crown 1 out to the second click.

B -Press Button A and Button B simultaneously.

C - Push Crown 1 back in to the normal position.

Zeroing the hands

After all reset the hands and calendar must be "Zeroed" to provide a starting point for setting the watch.

A - Pull Crown 1 out to the second click.

B - * Press Button A to move the chrono minute hand to the zero position.

C - * Press Button B to move the chrono second hand to the zero position.

D - Push Crown 1 back in to the normal position.

E - After adjusting the zero positions proceed to adjusting time and calendar.

* Keep the button pressed to move the hand rapidly.

Setting the Date

A - Pull Crown 1 out to the first click.

B - Turn the crown clockwise until the date for the previous day appears.

Page 1 Seiko Alarm Chrono Cal. 7T32 - Setting Instructions Created 05-07-2001 Refer to the instructions below for directions on how to set this watch Note: your watch may have a different case or face than the one shown in the pictures.
Page 2 C - Pull Crown 1 out to the second click and turn until the desired day appears. D - Push crown 1 back in to the normal position. Note: Do not set the date between 9:00 p.m. and 3:00 a.m. Otherwise the date may not change properly. Note: Since this watch is not a perpetual calendar it will be necessary to reset the date in February and 30 day months.
Page 3 C - Press Button B to Split/Split Release/Reset. Using Dual Time Display When the alarm is not in use the small alarm hands can be used to indicate the time in a different time zone. A - Pull Crown 2 out to the 2nd click and turn to set small alarm hands to the time of a different time zone. B - Push Crown 2 back in to the normal position.