Table of Contents
Advertisement
At trouble
At trouble
The reception results are successful
The reception results are successful
Misalignment
Misalignment
and the precise time is displayed, but
and the precise time is displayed, but
of the date
of the date
the date is not correctly displayed.
the date is not correctly displayed.
The crown or buttons
The crown or buttons
cannot be operated.
cannot be operated.
Operation
Operation
You get lost in
You get lost in
the middle of the
the middle of the
operation.
operation.
Blur on the dial glass
Blur on the dial glass
Others
Others
persists.
persists.
7
※ For the solution of troubles other than the above, consult the retailer from whom the watch was purchased.
156
In case of an abnormal movement
In case that the watch moves
abnormally or that the watch
does not move at one-second
i n t e r v a l s e v e n a f t e r f u l l y
charging the battery, perform
the procedures from ① - ⑦ for
normal function.
7
158
Possible cause
Possible cause
The date is out of the preliminary position.
The date is out of the preliminary position.
This happens when the date is out of the preliminary position as a result
This happens when the date is out of the preliminary position as a result
of influence of various external sources or after the built-in IC is reset.
of influence of various external sources or after the built-in IC is reset.
The stored electric power is running short.
The stored electric power is running short.
Hands and date are moving right after a setting
Hands and date are moving right after a setting
is carried out by the crown or button operation.
is carried out by the crown or button operation.
−−−−−−−−−−−−−−−−−−−−−−−−
−−−−−−−−−−−−−−−−−−−−−−−−
Small amount of water has got inside the watch
Small amount of water has got inside the watch
due to deterioration of the gasket, etc.
due to deterioration of the gasket, etc.
■ Reset the system ( ① - ② )
1
Pull the crown to the second
click
※ When the crown is
a screw lock type,
unlock it. → P.97
Pulling
0 1 2
the crown to
the second
click
※ Even after pulling the crown, the second
hand continues to move.
Solution
Solution
Set the date to the preliminary position "1" (the 1st).
Set the date to the preliminary position "1" (the 1st).
Sufficiently charge the watch until it starts moving at one-second
Sufficiently charge the watch until it starts moving at one-second
intervals.
intervals.
Wait without doing anything.
Wait without doing anything.
After the date stops, the crown and buttons can be operated.
After the date stops, the crown and buttons can be operated.
1. If the crown is pulled out, push it back in.
1. If the crown is pulled out, push it back in.
2. The watch will resume its normal one-second interval movements within 5 minutes.
2. The watch will resume its normal one-second interval movements within 5 minutes.
3. Start the setting procedure from the beginning.
3. Start the setting procedure from the beginning.
Contact the retailer from whom the watch was purchased.
Contact the retailer from whom the watch was purchased.
2
Press the button for 5 seconds and then release it
In five seconds after releasing the button, the hour hand starts to move
and stops at the 12 o'clock position. And then the minute hand and the
second hand start to move and stop at the zero second position.
※ The button cannot be operated
until all the hands stop.
Reference pages
Reference pages
P.160
P.160
P.112
P.112
−
−
−
−
−
−
7
157
※ Press the
Pressing
button with a
the button for
pointed object.
5 seconds and
7
release
→ P.96
Continue to the next page
159
Advertisement
Table of Contents
