Operation Method; Trial Run - Delta Electronics VFD-M Series User Manual

3.2 Operation Method

The operation method can be set via control terminals and LC-M02E keypad. Please choose a
suitable method depending on application and operation rule.
Operation Method
Operate from
external signal
External terminals input (multi-step speed function)
M2~M5 (Pr.39~Pr.42)
LC-M02E keypad

3.3 Trial Run

The factory setting of the operation source is from the digital keypad (Pr.01=00). You can perform a
trial run by using the digital keypad with the following steps:
1. After applying power, verify that the display shows F60.0Hz. When AC motor drive is in
standby situation, STOP LED and FWD LED will light up.
2. Press
RUN
3. Press
command is forward running. And if you want to change to reverse running, you should
press
Revision May 2008, ME14, SW V3.04
Frequency Source
Factory default
key to set frequency to 5Hz.
key, RUN LED and FWD LED will light up, which indicates operation
. And if you want to decelerate to stop, please press
Chapter 3 Keypad and Start Up|
Forward/Stop
Reverse/Stop
Reset
Multi-step 1
Multi-step 2
Multi-step 3
Common signal
Operation
Command Source
M0
M1
M2
M3
M4
M5
GND
E
M0-GND: FWD/Stop
M1~GND: REV/Stop
(Pr.01=01/02)
RUN
STOP
RESET
(Pr.00=00)
STOP
RESET
key.
3-5