Delta Electronics VFD-M Series User Manual page 76

Pr.45
Multi-function Output Terminal 1 (Photocoupler output)
Pr.46
Multi-function Output Terminal 2 (Relay output)
Settings 00 to 24
Settings Function
00 AC Drive Operational
Maximum Output
01
Frequency Attained
02 Zero speed
03 Over-Torque detection
Base-Block (B.B.)
04
Indication
05 Low-Voltage Indication
06 AC Drive Operation Mode
07 Fault Indication
Desired Frequency
08
attained
09 PLC Program Running
PLC Program Step
10
Completed
11 PLC Program Completed
12 PLC Operation Paused
13 Top Count Value Attained
Revision May 2008, ME14, SW V3.04
Terminal output is activated when there is power output
from drive.
Terminal output is activated when the AC drive attains
Maximum Output Frequency.
Terminal output is activated when Command Frequency is
lower than the Minimum Output Frequency.
Terminal output is activated when over-torque is detected.
Parameter Pr.61 determines the Over-Torque detection
level.
Terminal output is activated when the AC drive output is
shut-off by the external Base-Block.
Terminal output is activated when low voltage is detected.
Terminal output is activated when the operation of AC Drive
is controlled by External Control Terminals.
Terminal output is activated when certain faults occur (oc,
ov, oH, oL, oL1, EF, cF3, HPF, ocA, ocd, ocn, GF).
Terminal output is activated when the desired frequency
(Pr.47) is attained.
Terminal output is activated when the PLC program is
running.
Terminal output is activated for 0.5 sec. when each multi-
step speed is attained.
Terminal output is activated for 0.5 sec. when the PLC
program cycle has completed.
Terminal output is activated when PLC operation is paused.
Terminal output is activated when counter reaches the Top
Count Value. See diagram for Pr.38 to Pr.42=18.
Chapter 4 Parameters|
Factory Setting: 00
Factory Setting: 07
Description
4-41