Kyocera ECOSYS PA2100CX Operation Manual page 56

Installing and Setting up the Machine > Network Setup
2
3
4
5
6
Configuring the Connection by Using Push Button
When your computer or handheld device does not support Wi-Fi Direct but supports WPS, you can configure the
network using push button.
1
NOTE
Enter an ID consisting of between 1 and 16 numbers.
Select the [▲] or [▼] key to enter a number.
Select the [◄] or [►] key to move the cursor left or right.
The factory default settings for the administrator ID is set as 2100
3
Enter the administrator password and select the [OK] key.
NOTE
Enter a password consisting of between 0 (no settings) and 16 numbers.
Select the [▲] or [▼] key to enter a number.
Select the [◄] or [►] key to move the cursor left or right.
The factory default settings for the administrator password is set as 2100.
4 [▲] [] key > [Wi-Fi Direct] > [OK] key
Configure the settings.
[▲] [] key > [On] > [OK] key
Restart the network.
[Menu] key > [▲] [▼] key > [Wi-Fi Settings] > [►] key > [▲] [▼] key > [Restart Network] >
[OK] key > [OK] key
[Menu] key > [▲] [▼] key > [Wi-Fi Direct Set] > [►] key
Note the network name (SSID), IP address, and password.
Configure the handheld device.
1
[Settings] > [Wi-Fi]
2
Select the network name (SSID) appeared in step 5 from the list.
3
Enter the password that was provided in step 5 > [Connect]
The network between this machine and the handheld device is configured.
Display the screen.
1 [Menu] key > [▲] [▼] key > [Wi-Fi Direct Set] > [►] key
2
Enter the administrator ID and select the [OK] key.
NOTE
Enter an ID consisting of between 1 and 16 numbers.
Select the [▲] or [▼] key to enter a number.
Select the [◄] or [►] key to move the cursor left or right.
The factory default settings for the administrator ID is set as 2100.
2-27