Hoshizaki F-500BAJ Service Manual page 46

15) Replace the top and side panels in their correct positions.
16) Move the control switch to the "ICE" position.
17) Move the power switch to the "ON" position.
18) Replace the front panel in its correct position, then plug the appliance into the electrical
outlet (F-300BAJ) or turn on the power supply (F-500BAJ)..
7. Removal and Replacement of Gear Motor
1) Drain the water from the evaporator.
a) Remove the front panel, then move the power switch to the "OFF" position.
b) Move the control switch to the "DRAIN" position.
c) Move the power switch to the "ON" position and allow the water to drain from the
evaporator.
d) Move the power switch to the "OFF" position,then unplug the appliance from the
electrical outlet (F-300BAJ) or turn off the power supply (F-500BAJ).
2) Remove the top and side panels.
3) Remove the strap connecting the spout to the chute assembly, then remove the spout.
4) Remove the hex head bolts and washers securing the lower housing to the gear motor.
Lift the evaporator up slightly.
5) Remove the socket head cap screws and split lock washers securing the gear motor.
6) Disconnect the gear motor wiring, then remove the gear motor.
7) Remove the gear motor bracket and spline coupling from the old gear motor and place
on the new gear motor.
8) Install the new gear motor and re-connect the electrical wires.
9) Replace the removed parts in the reverse order of which they were removed.
10) Replace the top and side panels in their correct positions.
11) Move the control switch to the "ICE" position.
12) Move the power switch to the "ON" position.
13) Replace the front panel in its correct position, then plug the appliance into the electrical
outlet (F-300BAJ) or turn on the power supply (F-500BAJ)..
46