Table of Contents
Advertisement
1. Introduction and Installation
3
Load the paper, print-side up (2).
Important:
L Push and lock the plate (3) in the standard
input tray, if it is lifted.
2
4
Pinch the right side of the recording paper guide
(4), then slide it to match the paper size mark.
Pinch the front and back recording paper guides (5)
at the same time, then slide them together to match
the paper size mark.
5
L Make sure that the recording paper guides (6)
are at the paper size mark and the recording
16
3
5
5
Insert the standard input tray to the unit, lifting the
front part of the tray. Then push it completely into the
unit.
4
Note:
L If the paper is not loaded correctly, re-adjust the
paper guides, or the paper may jam.
L If the standard input tray does not close, the plate in
the standard input tray may be lifted. Push the paper
and make sure that the paper is laid flat in the
standard input tray.
paper is under the paper limit mark (7). The
paper should not be loaded over the tab (8).
6
7
6
8
Advertisement
Table of Contents
