Table of Contents
Advertisement
Settings
System
Network settings
Before you begin, contact your ISP (Internet Service Provider) to find out if your IP address is static. If it
is dynamic and you have a wired network, we recommend using the Automatic configuration procedures
described below.
Connect the STB to your router using a LAN cable before you start the configuration procedure.
To begin configuring your network connection, follow these steps:
Automatic
◈
1.
Press the MENU button on the remote control.
Select [Settings] > [System], and then press the ▶ button.
2.
3.
Select [Network settings], and then press the ▶ button.
4.
Select [Auto] in the Network Settings screen.
5.
Select [OK], and then press the " button. The STB detects the wired connection, verifies the network
connection and then connects to the network.
Manual
◈
If you have a static IP address or the Automatic procedure does not work, you'll need to set the Network
Settings parameters manually.
1.
Select [Manual] in the Network Settings screen.
2.
Enter IP address, Mask, Gateway and DNSs manually.
\ You can get the Network parameters from your Internet provider.
3.
Select [OK] to save settings, and then press the " button.
43
Advertisement
Table of Contents
