Samsung GX-SM550SM User Manual page 32

Settings
 Channel
◈ Installer settings
These settings should be done while mounting the
antenna with a motor and shouldn't be changed during
normal use. It is to set limits on the positioner motor
if the satellite dish can't move over whole driver angle
(~180 degrees). These limits are important because if
on the way of the dish from one side you have the wall
or someone remove the limits from this side, dish can
be destroyed.
In the [Installer settings], you will be able to:
- Set East limit
- Set West limit
- Go to initial position
- Disable limits
2. If the [Installation type] option is set to [SATCR], additional [Single Cable settings] option will appear in
[Channel] menu.
Single Cable settings
SatCR allows the connection up to 8 STBs via single
coaxial cable.
There are 4 and 8 slot devices available on the market.
Each device must be assigned to unique slot number
and its corresponding frequency.
Splitters must be used to connect STBs to common
coaxial cable.
SatCRs support switching between two satellites
(DiSEqC A and DiSEqC B) but this functionality is
implemented in only few devices.
For 4 slot SatCR the following frequencies for devices are available on market.
- 1210 MHz
For 8 slot SatCR the following frequencies for devices are available on market.
- 1284 MHz
- 1748 MHz
32
- 1420 MHz
- 1400 MHz
- 1864 MHz
- 1680 MHz
- 1516 MHz
- 1980 MHz
- 2040 MHz
- 1632 MHz
- 2096 MHz