Samsung GX-SM550SM User Manual page 31

Settings
 Channel
Positioner Settings
If you select one of the [Positioner] type (DiSEqC motor
or USALS), additional [Positioner Settings] option will
appear in the [Channel] menu. You are able to use one
of the following options: [User settings] or [Installer
settings].
◈ User settings
Accordingly which antenna motor type has been
selected, it's configuration can be done in user settings
window.
DiSEqC Motor settings
In this window, you are able to:
- < West : Drive West
- East > : Drive East
- Assign Sat. Position : Store a position
- Go To Sat. Position : Move to the stored position
For Drive West/East two options are possible in Motion
mode.
- [Continuous]: If you press the button, the motor
drives until the button is released.
- [Step]: If you press the button, the motor drives by
several degrees only.
Each satellite has its own slot number. So after
correcting dish adjustment, you must store it as the
current position. This stored position will be used for
the dish moving during scanning or channel change.
USALS settings
In this window, you are able to set longitude and
latitude coordinates of your antenna location. Based on
this coordinates all satellites positions will be calculated
automatically. It is possible to test settings by selecting
satellite with its transponder and press [Go To Sat.
Position]. Starting position of the dish can be restored
by pressing [Go to Position 0].
31