Button Sewing - Janome 5270QDC Instruction Book

q w e
4
r
q

Button Sewing

q Stitch pattern:
w Thread tension dial: 3 to 7
e Presser foot:
r Feed dog:
Lower the feed dog (refer to page 13).
Set the speed control slider at a slower speed.
Match the holes of button to the horizontal slot of the
presser foot and lower the foot to hold the button in place.
Adjust the stitch width so the needle will enter the left
hole of the button.
Turn the handwheel so that the needle will enter the
right hole of the button. Readjust the stitch width if
necessary.
q Stitch width (adjust to span of holes)
Stitch several times.
After you finish sewing, cut the thread but leave 4˝ (10 cm)
of threads at the end.
Pull the bobbin thread to draw the top thread to the
reverse side of the fabric and knot the threads.
After the button sewing is completed, raise the feed dogs
for normal sewing.
51
MODE 1: 7
MODE 2: 07
Satin stitch foot F
Lowered