Front Usb Board - HP Pavilion DV6-3030 Maintenance And Service Manual

Front USB board

NOTE: The front USB board and cable are included in the USB Board Kit, spare part number
603683-001.
Before removing the front USB board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
a. Accessory cover (see
b. Keyboard (see
c. Top cover (see
Remove the front USB board:
1. Release the ZIF connector to which the front USB board cable is connected, and then disconnect
the front USB board cable (1) from the system board.
2. Detach the front USB board cable from the clips (2) built into the base enclosure. (The front USB
board cable is also attached to the base enclosure with double-sided tape.)
3. Remove the front USB board (3).
Reverse this procedure to install the front USB board.
62 Chapter 4 Removal and replacement procedures
Battery on page 43), and then remove the following components:
Hard drive on page
Keyboard on page 54)
Top cover on page 57)
44)
ENWW