NOTE:
4.
Remove the display assembly (3).
5.
If it is necessary to replace the display bezel or any of the display assembly internal components:
a.
Remove the Mylar screw covers (1).
b.
Remove the two Phillips PM2.5×6.0 screws (2) that secure the display bezel to the display
assembly.
c.
Remove the hinge covers (3). The hinge covers are available using spare part number
606881-001.
d.
Flex the inside edges of the top edge (1), the left and right sides (2), and the bottom edge
(3) of the display bezel until the bezel disengages from the display enclosure.
ENWW
One of the screws on the left hinge secures a display panel ground loop (2).
Component replacement procedures
83