Table of Contents
Advertisement
CAUTION
Wear gloves and safety goggles and use
extreme CAUTION when installing these
handles. The rounded end of the handles
may be sharp (some models).
IMPORTANT
To ensure proper installation of handles, please
review these instructions and illustrations
thoroughly prior to installing the handles.
NOTE
All set screws should be tightened and sub-flush (Allen set screw should be seated just below
the surface of the end cap) of handle end cap. The end caps should be drawn tight to freezer
and refrigerator doors with no gaps.
Ensure Handle Set Screws are Facing Each Other with Doors Closed
HANDLE INSTALLATION
1 Remove handles from carton and any
other protective packaging.
2 Position freezer handle end caps over
upper and lower pre-installed shoulder
bolts (A) that are fastened into door,
ensuring the holes for the set screws are
facing towards the refrigerator door.
3 While holding handle firmly against door,
fasten upper and lower Allen set screws
(B) with supplied Allen wrench.
4 Repeat steps 2 and 3 to install refrigerator
handle. Ensure the holes for the set screws
are facing towards the freezer door.
Freezer
Refrigerator
Upper
Upper
End Cap
End Cap
Door
Door
Door
Door
Freezer
Refrigerator
Lower
Lower
End Cap
End Cap
9
Advertisement
Table of Contents
