Table of Contents
Advertisement
DOOR REMOVAL INSTRUCTIONS
To Remove Freezer Door:
1. Disconnect water line coming from lower
hinge of freezer door at connection
located under front of freezer: Press outer
ring against face of fitting, then pull to
remove tube.
2. Remove top hinge cover screw on freezer
door and remove cover.
3. Disconnect wiring harness connector plug
at top hinge: place your thumbs on flat
sides of each connector and bend both
parts back and forth, then with firm grasp,
pull both pieces apart.
4. Trace around hinge with soft lead pencil.
This will make it easier to realign doors
when they are replaced.
5. Remove top hinge, allowing wiring harness
to pull through hinge and lift freezer door
off of bottom hinge pin. Lay door down
flat to avoid kinking water line.
6. Remove bottom hinge, if necessary.
7. Reverse this procedure to reinstall freezer
door.
When both doors have been reinstalled,
connect water line by inserting tube and push
until mark touches face of fitting, replace toe
grille and plug in electrical power cord. Turn
both temperature controls to center position.
Adjust settings as necessary.
To Disconnect
1. Press outer ring against face of
fitting
2. Pull to
remove tube
To Connect
Insert tube and push until mark
touches face of fitting
8
Door
Hinge
Assembly
Screws
Water
Line
Tubing
Advertisement
Table of Contents
