Installation Instructions; Leveling Your Refrigerator; Electrical Requirements - Crosley CRH10SW User Instruction

Installation Instructions

Remove exterior and interior packings, wipe the outside thoroughly with a soft dry cloth and the inside with a wet,
lukewarm cloth. Avoid placing the unit in a narrow recess or near any heat source, direct sunlight, or moisture. Let
air circulate freely around the unit. Keep the rear of the refrigerator 2 inches away from the wall.
LOCATION
1) Select a place with a strong, level floor.
2) Allow 2 inches of space between the back of the refrigerator and any adjacent wall.
3) Avoid direct sunlight and heat. Direct sunlight may affect the acrylic coating. Heat sources nearby will cause
higher electricity consumption.
The refrigerating system in this refrigerator is a "Frost Free" system. This type of system requires no user interven-
tion (i.e. defrosting) other than selecting required cooling temperatures and the usual care and maintenance.
To avoid vibration, the unit must be set level. This is accomplished by adjusting the front leveling legs, located
under the refrigerator.
The refrigerator temperature will vary depending on the quantity of food stored and the frequency with which the door
is opened.
NOTES:
‡ This appliance is intended for FREE-STANDING INSTALLATION ONLY, and is NOT intended to be built-in.
‡ Before connecting this appliance to electrical power supply, leave it to stand for approx. 24 hours, which will
reduce the possibility of malfunction in the cooling system due to transport handling.
‡ This appliance is approved for INDOOR USE ONLY and is NOT intended for outdoor operation.

LEVELING YOUR REFRIGERATOR

r

ELECTRICAL REQUIREMENTS

This appliance must be grounded. In case of a short circuit, grounding reduces the risk of electric shock by providing
an escape for the electrical current.
This appliance is equipped with a cord having a grounding wire with a grounding plug. The plug must be plugged into
an outlet that is properly installed and grounded.
WARNING - Improper use of the grounding plug can result in a risk of electric shock. Consult a qualified electrician or
service man if the grounding instructions are not completely understood or if doubt exists as to whether the appliance is
properly grounded.
DO NOT USE AN EXTENSION CORD
Use an exclusive 115V wall outlet. Do not connect your refrigerator to extension cords or together with any other
appliance in the same wall outlet. Do not splice the cord.
Install this appliance in an area where the ambient temperature is
between 55°F (13°C) and 110°F (43°C). If the temperature around
the appliance is too low or high, cooling ability may be affected.