Crosley CRSE233TS0 Use & Care Manual page 25

CONCERN
DISPENSER (Ice & Water) (Continued)
Dispenser will
not dispense
water.
Water has an
odd taste and/
or odor.
Water pressure
is extremely
low.
Water not cold
enough.
OPENING/CLOSING OF DOORS/DRAWERS
Door(s) will not
close.
Drawers are
difficult to
move.
CAUSE
• Dispenser lock out is
engaged.
• Water filter not seated
properly.
• Water filter is clogged.
• Household water line
valve is not open.
• Water has not been dis-
pensed for an extended
period of time.
• Unit not properly con-
nected to cold water line.
• Cut-off and cut-on pres-
sures are too low (well
systems only).
• Reverse osmosis system
is in regenerative phase.
• As warmer tap water goes
through the filter and
enters the water tank the
chilled water is pushed
through to the dispenser.
Once the chilled water is
used up it will take several
hours to bring the freshly
replaced water to a cooler
temperature.
• Some models are
designed without a
water tank, these water
dispensing systms are not
designed to chill water.
• Door was closed too
hard, causing other door
to open slightly.
• Refrigerator is not level.
It rocks on the floor
when moved slightly.
• Refrigerator is touching a
wall or cabinet.
• Food is touching shelf on
top of drawer.
• Track that drawers slide
on is dirty.
BEFORE YOU CALL
SOLUTION
• Press and hold control lock for three
seconds.
• Remove and reinstall the water filter. Be
sure to push the filter firmly so that you
hear it lock solidly into position.
• Replace filter cartridge. Be sure to remove
protective caps and push the filter firmly so
that you hear it lock solidly into position.
• Open household water line valve. See CON-
CERN column AUTOMATIC ICE MAKER.
• Draw and discard 10-12 glasses of water
to freshen the supply.
• Connect unit to cold water line that sup-
plies water to the kitchen faucet.
• Have someone turn up the cut-off and
cut-on pressure on the water pump sys-
tem (well systems only).
• It is normal for a reverse osmosis system to be
below 20 psi during the regenerative phase.
• Add ice to cup or container before dis-
pensing water.
• Add ice to cup or container before dis-
pensing water
• Close both doors gently.
• Ensure floor is level and solid, and can
adequately support the refrigerator. Contact a
carpenter to correct a sagging or sloping floor.
• Ensure floor is level and solid, and can
adequately support the refrigerator. Contact a
carpenter to correct a sagging or sloping floor.
• Remove top layer of items in drawer.
• Ensure drawer is properly installed on
track.
• Clean drawer, rollers, and track. See Care
& Cleaning.
25