Table of Contents
Advertisement
Calls can be made using the following commands:
Dial
Digit Dial
Call
Re dial
1. Press and hold
responds with Ready followed by a tone.
2. Say Dial . The system responds with Dial using
<phone name> . Number please followed by
a tone.
3. Say the entire number without pausing.
If the system recognizes the number, it
responds with OK, Dialing and dials the
number.
If the system does not recognize the number, it
confirms the numbers followed by a tone. If the
number is correct, say Yes . The system
responds with OK, Dialing and dials the
number. If the number is not correct, say No .
The system will ask for the number to be
re entered.
for two seconds. The system
1. Press and hold
responds with Ready followed by a tone.
2. Say Digit Dial . The system responds with Digit
dial using <phone name>, please say the first digit
to dial followed by a tone.
3. Say the digit to be dialed one at a time. Following
each digit, the system will repeat back the digit it
heard followed by a tone.
4. Continue entering digits until the number to be
dialed is complete. After the whole number has
been entered, say Dial . The system responds
with OK, Dialing and dials the number.
If an unwanted number is recognized by the
system, say Clear at any time to clear the last
number.
To hear all of the numbers recognized by the
system, say Verify at any time and the system
will repeat them.
for two seconds. The system
4-127
Advertisement
Table of Contents
