Kenwood DPX-MP4050B Instruction Manual page 35

?
The songs in the selected folder aren't played in Folder Select
mode.77
✔ There are no MP3 in the selected folder.
☞ Make sure there's recorded content in the MP3 media.
?
The MP3 File/Folder search takes
✔ Many files are recorded on the media.
☞ When the media directory is complex, the file/folder search can
take time.
?
The MP3 related text isn't displayed
✔ A character is entered that this unit can't display.
☞ For the characters that can be used for MP3 text entry, refer to
<Notes on playing MP3> (page 6).
?
The MP3 file time isn't displayed
✔ ---
☞ There are times when it isn't displayed correctly according to the
MP3 recording conditions.
?
The songs in the selected folder aren't played in Folder Select
mode.102
✔ There are no MP3 in the selected folder.
☞ Make sure there's recorded content in the MP3 media.
If the following situations, consult your nearest service
center:
• Even though the disc changer is connected, the Disc Changer source is
not ON, with "AUX" showing in the display during the Changer Mode.
• Even though no device (KCA-S210A, CA-C1AX, KDC-CPS89, KDC-CPS87,
KDC-CX87, KDC-CPS85, KDC-CX85, KDC-CPS82 or KDC-CX82) is
connected, the Auxiliary input is entered when switching modes.
time.78
correctly.79
correctly.80
The messages shown below display your systems
condition.
EJECT: No disc magazine has been loaded in the changer.
The disc magazine is not completely loaded.
Load the disc magazine properly.
➪
No CD in the unit.
Insert the CD.
➪
No Disc: No disc has been loaded in the disc magazine.
Load a disc into the disc magazine.
➪
Error 04: No disc has been loaded in the disc magazine.
Load a disc into the disc magazine.
➪
The CD is quite dirty. The CD is upside-down. The CD
is scratched a lot.
Clean the CD and load it correctly.
➪
Error 05: The CD is upside-down.
Load the CD correctly.
➪
Blank: Nothing has been recorded on the MD.
No Track: No tracks are recorded on the MD, although it has a
title.
E11
No Music: Media was played that doesn't have data recorded
that the unit can play.
Use media that has data recorded that the unit can
➪
play.
Error 30: The faceplate of the slave unit being connected to
this unit has been removed.
Replace it.
➪
Error 77: The unit is malfunctioning for some reason.
Press the reset button on the unit. If the "Error 77"
➪
code does not disappear, consult your nearest
service center.
— 35 —
E01
E02
E04
E05
E10
E15
E30
E77