Kenwood DPX-MP4050B Instruction Manual page 33

Tuner source
?
Radio reception is poor.39
✔ The car antenna is not extended.
☞ Pull the antenna out all the way.
✔ The antenna control wire is not
☞ Connect the wire correctly, referring to the section on
<Connecting Wires to Terminals> (page 30).
?
The desired frequency can't be entered with the Direct Access
Tuning.41
✔ A station that can't be received is being entered.
☞ Enter a station that can be received.
✔ You're trying to enter a frequency with a 0.01 MHz
☞ What can be designated in the FM band is to 0.1 MHz.
Cassette tape source
?
Can't remove tape.44
✔ The cause is that more than 10 minutes has elapsed since the vehicle
ACC switch was turned OFF.
☞ The tape can only be removed within 10 minutes of the ACC
switch being turned OFF. If more than 10 minutes has elapsed,
turn the ACC switch ON again and press the Eject button.
?
The DPSS, Tape Advance and Music Repeat don't operate
correctly.45
✔ The space between the songs on the tape can't be recognized
because it's too short.
☞ Have at least 4 seconds between songs.
✔ The space between songs can't be recognized because there's too
much noise between songs.46
☞ Reduce the noise between songs.
?
The blank skip doesn't work.47
✔ Because noise is too loud, the non-recorded part can't be recognized.
☞ Reduce the noise between songs.
?
Blank Skip functions at places that are
✔ Because the recording level is low, it's recognized as not recorded.
☞ Turn Blank Skip OFF.
connected.40
unit.42
recorded.48
Disc source
?
"AUX" is displayed without achieving External disc control
✔ O-N switch is set to "O" side.
☞ Set the switch to "N" side.
✔ Unsupported disc changer is
☞ Connect the supported disc changer. (page 3)
?
The specified disc does not play, but another one plays
✔ The specified CD is quite dirty.
☞ Clean the CD.
✔ The CD is upside-down.53
☞ Load the CD with the labeled side up.
✔ The disc is loaded in a different slot from that
☞ Eject the disc magazine and check the number for the specified
disc.
✔ The disc is severely scratched.55
☞ Try another disc instead.
?
The specified track will not
✔ Random play or magazine random play has been selected.
☞ Turn off random play or magazine random play.
?
Track repeat, disc repeat, track scan, random play, and magazine
random play start by themselves.59
✔ The setting is not canceled.
☞ The settings for these functions remain on until the setting to off
or the disc ejected, even if the power is turned off or the source
changed.
?
Cannot play CD-R or CD-RW.60
✔ Finalization processing is not being conducted for CD-R/CD-RW.
☞ Conduct finalization processing with CD recorder.
✔ A non-compatible CD changer is being used to play the CD-R/CD-
RW.61
☞ Use a CD changer compatible with CD-R/CD-RW to play.
?
A CD ejects as soon as it is
✔ The CD is upside-down.
☞ Load the CD with the labeled side up.
✔ The CD is quite dirty.63
☞ Clean the CD, referring to the section on <CD cleaning> (page 5).
— 33 —
mode.50
connected.51
instead.52
specified.54
play.58
loaded.62