Assembly - Grizzly G1030 Owner's Manual

assembly

To assemble your machine:
1.
position the base plate upside down and
mount the casters to the base plate using
(16) ⁄ "-18 x ⁄ " flange bolts, as shown in
5 1
16 2
figure 3.
figure 3. Mounting casters to base.
2. set the collector body on top of the base
plate so the intake portion is near the edge of
the base plate and the bolt holes are aligned,
as shown in figure 4. secure the collector
body to the base plate with (4)
flange bolts.
Collector Body
Flange Bolts
figure 4. Mounting collector to base.
g1030 dust Collector
3.
figure 5. Mounting outlet to collector body.
4.
⁄ "-18 x ⁄ "
5 1
16 2
insert one of the rubber gasket between the
collector and lower outlet flange, and secure
using (8) ⁄ "-18 x ⁄ " flange bolts, as shown
5 1
16 2
in figure 5.
Note: When connecting parts that have a
gasket between them, always tighten the fas-
teners in a diagonal and rotational manner to
ensure the gasket does not become crimped
and the seal compromised.
lower outlet Flange
insert one of the rubber gaskets between the
outlet flange and the collector flange. secure
with eight (8) ⁄ "-18 x
5
16
repeat the procedure for the other collector
on the opposite side (see figure 6).
Note: The inside of the collectors are funnel
shaped and force the air around in a cyclone
motion. Make sure that the inside taper (fun-
nel) is facing downward and that the collector
inlet flange faces toward the collector body.
gasket
figure 6. Collector secured to outlet.
⁄ " bolts provided.
1
2
-11-