Assembly - Grizzly G0785 Owner's Manual

Assembly

For adequate motor cooling, the motor fan intake
must not be restricted by a wall or cabinet.
To assemble and mount dust collector:
1.
Fasten motor mounting plate to motor base
with (4) ⁄ -20 x ⁄
1 1
4 2
8).
Flange Bolt
Bag Clamp
Figure 8. Dust collector assembly diagram.
2.
Using wall bracket as a template, mark
mounting hole location so bottom of bracket
is a minimum of 56" from floor and at least
" away from any wall, as shown in Figure
4 ⁄
1
2
9.
Note: Drawing
Not to Scale.
Floor
Figure 9. Wall bracket positioning.
Model G0785 (Mfd. Since 3/15)
" flange bolts (see Figure
Wall
Bracket
Motor Mounting
Plate
Wall
Minimum
4 / "
1
2
Wall
56"
Minimum
— If mounting to a wood framed wall (with or
without drywall), bracket must be mounted
directly to a support board that is wide
enough to span and mount onto two wall
studs. Mount support to wall studs with lag
screws, then mount bracket to support with
appropriate fasteners, as shown in Figure
10.
Wall
Lag Bolt
Bracket
Support
Board
Figure 10. Wall bracket secured to support
board on wall studs.
— If mounting to a concrete or masonry wall,
attach bracket using lag shield anchors
with lag screws or anchor studs (see
Figure 11).
Anchor Stud
Figure 11. Typical fasteners for mounting dust
collector bracket to masonry or concrete walls.
3.
After wall bracket is installed, have another
person help you hang dust collector on
bracket.
4.
Install dust collection bag with bag clamp
(see Figure 8), then connect ducting. Refer
to Collection System on next page for
grounding requirements.
Wall Stud
Lag Shield Anchor
and Lag Screw
-15-