Setup; Ac Power; Ac Plug; Fuse Replacement - Chauvet Q-WASH 260-LED User Manual

Chauvet work light - led work light user manual
Hide thumbs Also See for Q-WASH 260-LED:
Table of Contents

Advertisement

Setup

3. Setup

AC Power

AC Plug

Fuse Replacement

-6-
The Q-Wash 260-LED has an auto-ranging power supply that can work with an input
voltage range of 100~240 VAC, 50/60 Hz.
Make sure that you are connecting this product to the proper voltage, as per the
specifications in this guide or on the product's sticker.
Always connect this product to a protected circuit with an appropriate electrical
ground to avoid the risk of electrocution or fire.
To determine the power requirements for the Q-Wash 260-LED see the label affixed to the
side of the product. Alternatively, you may refer to the Technical Specifications chart in the
Technical Information chapter of this manual.
The listed current rating indicates the maximum current draw during normal operation. For
more information, you may download the "Sizing the Circuit Breakers" document from the
CHAUVET® web site: www.chauvetpro.com.
Never connect this product to a rheostat (variable resistor) or dimmer circuit, even if
the rheostat or dimmer channel serves only as a 0 to 100% switch.
The Q-Wash 260-LED comes with a power input cord terminated with an IEC connector on
one end an Edison plug on the other end (US market). If the power input cord that came
with your product has no plug or you need to change the Edison plug, use the table below
to wire the new plug.
Connection
AC Live
AC Neutral
AC Ground
Make sure to disconnect the product's power cord before replacing a blown fuse,
and always replace it with a fuse of the same type and rating.
1. Wedge the tip of a flat head screwdriver into the slot of the fuse holder and
pry it out of its housing.
2. Remove the blown fuse from its holder and replace it with a fuse of the exact
same type and rating.
3. Insert the fuse holder back in its place, and reconnect power.
Wire (US)
Wire (Europe)
Black
White
Green/Yellow
Green/Yellow
The fuse is located
inside this compartment.
Remove it using a flat
head screwdriver.
Screw Color (US)
Brown
Yellow or Brass
Blue
Silver
Green
Q-Wash 260-LED User Manual Rev. 05

Advertisement

Table of Contents
loading

Table of Contents