Heat & Glo 6000CL-IFT-S Owner's Manual page 21

Note: The base refractory must be
removed to access screws.
Figure 4.6 Base Refractory Removal
Figure 4.8 Burner Identification
BASE REFRACTORY
6000CL
8000CL
Heat & Glo • 6000CL-IFT, 8000CL-IFT Owner's Manual • 2504-981 Rev. K • 12/20
Figure 4.7 Valve Assembly Removal
Burner Identification/Verification
The burner may be accessed for identification and veri-
fication purposes. This task should be performed by a
qualified service technician. The base refractory, valve
plate, refractory panels and grate do not need to be re-
moved to access the burner assembly. The logs and fi-
ber burner top need to be removed to access the burner.
Disconnect the pilot from the burner before removal. See
Figure 4.8 for burner identification chart. Notch patterns
are located on bottom side of burner.
NG PROPANE
NOTCH LOCATION
Note: Notch location may vary by model.
21