Setup; Ac Power; Ac Plug; Fuse Replacement - Chauvet Legend 1200E Spot User Manual

3. Setup

AC Power

AC Plug

Fuse Replacement

DMX Linking

DMX Modes

Legend™ 1200E Spot User Manual Rev. 03c
The Legend™ 1200E Spot has an auto-ranging power supply that can work with an
input voltage range of 200~240 VAC, 50/60 Hz.
Make sure that you are connecting this product to the proper voltage, as per the
specifications in this guide, the product's user manual, or on the product's sticker.
Always connect the Legend™ 1200E Spot to a protected circuit with an
appropriate electrical ground to avoid the risk of electrocution or fire.
To determine the power requirements for the Legend™ 1200E Spot see the label affixed
to the bottom of the fixture. Alternatively, you may refer to the corresponding
specifications chart in the Technical Information chapter of this manual.
The listed current rating indicates the maximum current draw during normal operation.
For more information, you may download the "Sizing the Circuit Breakers" document
from the CHAUVET® Web site.
Never connect the Legend™ 1200E Spot to a rheostat (variable resistor) or
dimmer circuit, even if the rheostat or dimmer channel serves only as a 0 to 100%
switch.
The Legend™ 1200E Spot has a bare-ended power input cord that is hard-wired to the
base of the fixture. Use the table below to wire a plug for the power cord.
Connection
Wire (US)
AC Live
AC Neutral
AC Ground
Green/Yellow
Make sure to disconnect the fixture's power cord before replacing a blown fuse,
and always replace it with a fuse of the same type and rating.
1) With a Phillips #2 screwdriver, unscrew the fuse holder from its housing.
2) Remove the blown fuse from its holder and replace it with a good fuse of the exact
same type and rating.
3) Screw the fuse holder back in its place and reconnect power.
You may link any Legend™ 1200E Spot fixture to a DMX controller using a standard
DMX serial connection. If using other DMX compatible fixtures with a Legend™ 1200E
Spot, it is possible to control them individually with a single DMX controller.
If you are not familiar with the DMX standard, or if you need information about the DMX
cables needed to link the Legend™ 1200E Spot fixture to a DMX controller, you may
download the "DMX Primer" document from the CHAUVET® Web site.
The Legend™ 1200E Spot can operate in 23 and 31-channel DMX modes. You will find
information about these DMX modes in the Introduction chapter (brief description), the
Operation Instructions chapter (configuration details), and the DMX Values section
(individual channel values).
Wire (Europe)
Black Brown
White Blue
Green/Yellow
Setup
Screw Color
Yellow or Brass
Silver
Green
-7-