Error Messages - Chauvet Legend 1200E Spot User Manual

Technical Information

Error Messages

Message
Lamp Startup Fail
Temperature Sense Fail
Lamp Hot Protection
Lamp Hot Power Off
Maintenance Fixture
Lamp On Over 700 Hour
Memory Initial Fail
Fan 1 Error
Fan 2 Error
Fan 3 Error
Fan 4 Error
Fan 5 Error
Fan 6 Error
CPU-B Error
CPU-C Error
CPU-D Error
CPU-E Error
CPU F Error
CPU G Error
CPU H Error
Pan Home Sensor Error
Pan Encode Error
Tilt Home Sensor Error
Tilt Encode Error
Color 1 Reset Fail
Cyan Reset Fail
Magenta Reset Fail
Yellow Reset Fail
3200 K Filter Reset Fail
Gobo 1 Reset Fail
R-Gobo 1 Reset Fail
Gobo 2 Reset Fail
R-Gobo Reset Fail
Iris Reset Fail
Effect Reset Fail
R-Effect Reset Fail
Frost Reset Fail
Focus Reset Fail
Zoom Reset Fail
-28-
Cause(s)
The lamp has not started after being
struck.
There is no communication with
temperature sensor.
Fixture temperature is higher than 105º C;
lamp was switched to low power for safety.
Fixture temperature is 110º C or higher;
lamp was switched to off for safety.
Fixture Maintenance timer expired.
Lamp change is overdue.
Memory chip error found.
The indicated fan is not working.
There is no communication with the
indicated auxiliary CPU.
The moving head failed going to home
position after power up or fixture reset.
The indicated moving part failed going to
home position after power up or fixture
reset.
Action(s)
•
Check lamp
•
Check lamp socket and wiring
•
Check ballast and igniter
•
Check sensor wiring
•
Check sensor integrity
•
Check control board
•
Check fans
•
Check fan wiring
•
Clean vents
•
Check fans
•
Check fan wiring
•
Clean vents
•
Proceed with maintenance and reset timer
•
Change lamp
•
Change main board
•
Check fan
•
Check fan wiring
•
Check sensors' wiring and position
•
Check stepper motor, belt, and driver board
•
Check control boards
•
Check moving head's free movement
•
Check sensors' wiring and position
•
Check stepper motor, belt ,and driver board
•
Check the corresponding control board
•
Check main control board
•
Check part's free movement and integrity
•
Check sensors' wiring and position
•
Check stepper motor, belt, and driver board
•
Check the corresponding control board
•
Check main control board
Legend™ 1200E Spot User Manual Rev. 03c