Offset Mode; Entering Offset Mode - Chauvet Legend 1200E Spot User Manual

Operation
Factory Default

Offset Mode

Entering Offset
Mode
Pan Motor
Tilt Motor
Shutter Motor
Color Motor
Cyan Dichroic Flag Motor
Magenta Dichroic Flag
Motor
Yellow Dichroic Flag
Motor
3200 K Filter Dichroic Flag
Motor
Gobo 1 Motor
-20-
Continued from previous page
If you want to default the fixture to its factory configuration, follow the following steps:
1) Select Factory Settings.
3) Select Yes (default fixture) or No (exit without defaulting).
4) Press <ENTER>.
•
The above operation will default all the fixture's parameters to their original
factory configuration values.
•
Defaulting the fixture does not affect the home position settings.
The Offset Mode provides fine adjustments for the home position of all the moving parts
in the optical path as well as the pan and tilt movements. The home position is where
the moving parts go when you reset them. In their corresponding home position, the
moving parts should not show any border or reduce the light output. If they do, use the
Offset Mode to fine adjust them.
1) Press <MENU> to enter the regular Menu Mode.
2) Press <ENTER> for more than three seconds to enter the Offset Mode (the Offset
Mode menu will show).
4) Press <MENU> to exit once you are done with offset adjustments.
1) Select Pan and press <ENTER> (a pop up window will open).
a) Select the new value (-128~127).
b) Accept the new value.
1) Select Tilt and press <ENTER> (a pop up window will open).
a) Select the new value (-128~127).
b) Accept the new value.
1) Select Shutter and press <ENTER> (a pop up window will open).
a) Select the new value (0~255).
b) Accept the new value.
1) Select Color 1 and press <ENTER> (a pop up window will open).
a) Select the new value (-128~127).
b) Accept the new value.
1) Select Cyan and press <ENTER> (a pop up window will open).
a) Select the new value (0~255).
b) Accept the new value.
1) Select Magenta and press <ENTER> (a pop up window will open).
a) Select the new value (0~255).
b) Accept the new value.
1) Select Yellow and press <ENTER> (a pop up window will open).
a) Select the new value (0~255).
b) Accept the new value.
1) Select 3200 K Filter and press <ENTER> (a pop up window will open).
a) Select the new value (0~255).
b) Accept the new value.
1) Select Gobo 1 and press <ENTER>.
a) Select the new value (-128~127).
b) Accept the new value.
Continues on the next page
Legend™ 1200E Spot User Manual Rev. 03c