Operation - Greenlee GT-65e Instruction Manual

Operation

Electric shock hazard:
• Do not change the measurement function while the test leads are
connected to a component or circuit.
• If the tester is used in a noisy environment, ensure that the sound
level of the tester is perceptible.
Failure to observe these precautions may result in injury and can damage
the unit.
1. Refer to "Typical Measurements" for specific measurement instructions.
2. Refer to the Test Table for test instructions.
3. Perform the Indicator Self-Test as described in "Using the Features."
Test the unit on a known functioning circuit or component.
• If the unit does not function as expected on a known functioning
circuit, replace the batteries.
• If the unit still does not function as expected, send the unit to
Greenlee for repair. Refer to the instructions under the Warranty.
4. Take the reading from the circuit or component to be tested. Do not
cover the LEDs or LCD, before or during the test. The LEDs illuminate as
shown in the LED Table.
5. Test the unit again on a known functioning circuit or component in order
to verify that the tester is still working.
Electric shock hazard:
Contact with live circuits could result in severe
injury or death.
GT-65e • GT-95e
9