Operation - Greenlee PairMapper Instruction Manual

Features
• Testing for wiring faults of open, shorted, reversed, crossed, and split pairs
• Split pair fault detection at a minimum 0.4 m (16") cable length
• Testing of twisted pair cables to over 200 m (656 ft)
• Tone generator for tracing installed cables and locating faults
• One-person identification of up to four remote terminators
• Verification of shield integrity
• Easy-to-read fault display and high speed testing
• "Debug mode" for detailed fault identification results
• "Auto sleep mode" and power off switch to decrease power consumption

Operation

Testing a Cable
1. Slide the switch to Cable.
2. Plug one end of the cable into the RJ45 jack on the main unit and the other end into the
RJ45 jack on any remote terminator.
3. Press the TEST button and check the results:
• First, check the five horizontally aligned green LEDs (1-2, 3-6, 4-5, 7-8, and SHIELD):
Solid light:
Flashing light:
No light:
• Simultaneously, check the first four vertically aligned LED indicators (SHORT,
REVERSED, MISWIRE, and SPLIT PAIRS) to identify any existing wiring faults.
• For more detailed information about what faults are occurring in which pairs, hold the
TEST button for 2 seconds to activate "debug mode." The tester will test each pair one
by one, pausing briefly on each pair, and display the corresponding fault status.
6
Good pair
Faulted pair
Open pair