Manage Dynamic Dns - NETGEAR Orbi LBR1020 User Manual

Router Information Protocol (RIP) allows a router to exchange routing information
with other routers.
a. Select the RIP direction:
• Both. The router broadcasts its routing table periodically and incorporates
information that it receives.
• Out Only. The router broadcasts its routing table periodically.
• In Only. The router incorporates the RIP information that it receives.
b. Select the RIP version:
• Disabled. This is the default setting.
• RIP-1. This format is universally supported. It is adequate for most networks,
unless you are using an unusual network setup.
• RIP-2. This format carries more information. Both RIP-2B and RIP-2M send the
routing data in RIP-2 format. RIP-2B uses subnet broadcasting. RIP-2M uses
multicasting.
8. Click the Apply button.
Your settings are saved.
If you changed the LAN IP address of the router, you are disconnected when this
change takes effect.
9. To reconnect, close your browser, relaunch it, and log in to the router.

Manage Dynamic DNS

Note: Dynamic DNS works only if the router's IP address is a public IP address. However,
with a mobile broadband connection, your LTE provider usually assigns the router a
private IP address, in which case Dynamic DNS does not function. This limitation does
not apply to a wired Internet connection. For more information about Dynamic DNS
with a mobile broadband connection, contact your LTE provider.
Internet service providers (ISPs) assign numbers called IP addresses to identify each
Internet account. Most ISPs use dynamically assigned IP addresses. This means that the
IP address can change at any time. You can use the IP address to access your network
remotely, but most people don't know what their IP addresses are or when this number
changes.
To make it easier to connect, you can get a free account with a Dynamic DNS service
that lets you use a domain name to access your home network. To use this account, you
Specify Network Settings
Orbi 4GX Router Model LBR1020
80 User Manual