Table of Contents
Advertisement
Operation (cont'd)
Crimping
Setup
1. Open the tool head.
2. Remove any accessories from the tool head.
3. Select the appropriate set of dies. Use the
table provided on this page to select the
corresponding adapter set.
4. Install the adapters and dies—one set in each
groove. If either the adapters or dies have W-type
tabs, lock them in place with the W-type detents.
Important: W-type dies must be locked into place
or the die detents will be damaged.
5. Visually check the dies to ensure that they are
aligned correctly so that they will complete the
crimping operation.
6. Close the tool head.
Greenlee / A Textron Company
CCCX and CCCXC Tools
Accessory Table
Dies
Greenlee K22, KA22, KC22-type
Greenlee W-type
Kearney "OD"
Thomas & Betts "6TON"
D
Profile
3
Blackburn
®
"O"
Huskie "HT"
FCI Burndy "W"
Huskie "HT-58"
Ilsco "ND-60"
Izumi "N58"
Panduit "CD-2001"
W-type
K22-type
Important: W-type dies
must be locked into
place or the die detents
will be damaged.
8
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
Adapter Set
UA22
UAW
UAK
UAK
UAW
UAK
UAK
UAW
UAW
UAW
UAW
UAW
Kearney
W-type Detents: Press
and slide the adapter
and/or die into place.
Release to lock.
Advertisement
Table of Contents
