Punching - Greenlee CCCX Instruction Manual

Operation (cont'd)

Punching

Electric shock hazard:
Do not use this tool as a punch
driver on or near live circuits. This
includes, but is not limited to, the
following circumstances:
• Energized electrical lines
• Energized circuit breaker panels
and fuse boxes
• Junction boxes with energized
circuits
Failure to observe this warning could
result in severe injury or death.
Wear eye protection when operating
or servicing this tool.
Failure to wear eye protection could
result in serious eye injury from
flying debris or hydraulic oil.
Do not attempt to punch a hole
through two or more thicknesses of
material. This will bend or break the
draw stud, and could throw parts
with great force.
Failure to observe this warning could
result in severe injury or death.
Greenlee / A Textron Company
CCCX and CCCXC Tools
A component failure could throw
broken parts.
• Do not allow anyone to stand in
front of the punch.
• Close access doors or covers on
any equipment that is in line with
the punch.
Failure to observe this warning could
result in severe injury or death.
Set up the tool properly. An improper setup could
cause a component to fail and strike nearby
personnel with great force.
• Thread the punch completely onto the draw stud.
All of the punch threads must be engaged by the
draw stud threads. Incomplete assembly could
cause a component failure.
• Use only Greenlee punches, dies, and draw
studs. Other manufacturers' components might
not withstand the forces generated by this punch
driver.
Failure to observe these warnings could result in
severe injury or death.
11
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070