Cutting - Greenlee CCCX Instruction Manual

Operation (cont'd)

Cutting

Electric shock hazard:
This tool is not insulated. When using
this unit as a cable cutter on or near
energized electrical lines, use proper
personal protective equipment.
Failure to observe this warning could
result in severe injury or death.
Wear eye protection when operating
or servicing this tool.
Failure to wear eye protection could
result in serious eye injury from
flying debris or hydraulic oil.
Setup
1. Open the tool head.
2. Remove any accessories from the tool head.
3. Select the appropriate set of blades, using the
table provided on this page.
4. Install one blade in each groove. If the blades have
W-type tabs, lock them in place with the W-type
detents.
Important: W-type dies must be locked into place
or the die detents will be damaged.
5. Visually check the blades to ensure that they are
aligned correctly so that they will complete the
butting operation.
6. Close the tool head.
Setup for Din Rail Cutters
1. Install both blades in the movable head.
2. Close the head.
3. Slide one blade over until it engages in the W-type
detents.
Greenlee / A Textron Company
CCCX and CCCXC Tools
Accessory Table
Task
Copper and aluminum
26 mm (1.00") max.
Copper and aluminum
40 mm (1.56") max.
ACSR
Copperweld
ACAR
Guy strand
EHS guy strand
Ground rod
Anchor rod
Soft bolts
Rebar
Threaded rod
DIN rail
Cutting Procedure
1. Press the latch and open the tool head.
2. Position the item to be cut in the tool head.
3. Close the tool head.
4. Pull the trigger to cut the item.
5. Release the trigger when the cut is complete.
6. The ram returns automatically.
10
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
Blade
UC26
UC40
UCACSR
Threaded rod
DIN rail