Table 8: Ht488 Basic Settings - Grandstream Networks HT-488 User Manual

T 8: HT488 B S
ABLE ASIC
End User
Password
Web Port
IP Address
DHCP hostname
DHCP domain
DHCP vendor class ID
Time Zone
Daylight Savings Time
Grandstream Networks, Inc.
P D
ETTINGS AGE EFINITIONS
This contains the password for end user to access the Web Configuration
Menu. User can put new password here. This field is case sensitive with
maximum of 25 characters
This is the device's internal HTTP server port. Default is 80.
- If DHCP mode is enabled, then all the field values for the Static IP mode are
not used (even though they are still saved in the Flash memory.) The HT386
will acquire its IP address from DHCP in the network.
PPPoE settings is usually for DSL/ADSL modem users. The HT will attempt to
establish a PPPoE session if PPPoE account is set.
- If Static IP mode is selected, the IP address, Subnet Mask, Default Router IP
address, DNS Server 1 (mandatory), DNS Server 2 (optional) fields need to be
configured.
This option specifies the name of the client. This field is optional but may be
required by some Internet Service Providers. Default is blank.
This option specifies the domain name that client should use when resolving
hostnames via the Domain Name System. Default is blank.
This option is used by clients and servers to exchange vendor-specific
information. Default is blank.
This parameter controls how the displayed date/time will be adjusted
according to the specified time zone.
This parameter controls whether the displayed time will be daylight savings
time or not. If set to "Yes" and the Optional Rule is empty, then the displayed
time will be 1 hour ahead of normal time.
The "Automatic Daylight Saving Time Rule" shall have the following syntax:
start-time;end-time;saving
Both start-time and end-time have the same syntax:
month,day,weekday,hour,minute
month: 1,2,3,..,12 (for Jan, Feb, .., Dec)
day: [+|-]1,2,3,..,31
weekday: 1, 2, 3, .., 7 (for Mon, Tue, .., Sun), or 0 which means the daylight
saving rule is not based on week days but based on the day of the month.
hour: hour (0-23),
minute: minute (0-59)
If "weekday" is 0, it means the date to start or end daylight saving is at exactly
the given date. In that case, the "day" value must not be negative. If "weekday"
is not zero and "day" is positive, then the daylight saving starts on the first
"day"th iteration of the weekday (1st Sunday, 3rd Tuesday etc). If "weekday"
us not zero and "day" is negative, then the daylight saving starts on the last
"day"th iteration of the weekday (last Sunday, 3rd last Tuesday etc).
The saving is in the unit of minutes. The saving time may also be preceded by
a negative (-) sign if subtraction is desired instead of addition.
The default value for "Automatic Daylight Saving Time Rule" shall be set to
"04,01,7,02,00;10,-1,7,02,00;60" which is the rule for US.
Examples
US/Canada where daylight saving time is applicable:
HT488 User Manual
Firmware 1.0.3.86
Page 20 of 31
Last Updated: 7/2007