Figure 3: Screenshot Ofc; Table 7: Ht488 Device Status; Definitions; Page Definitions - Grandstream Networks HT-488 User Manual

F 3: S
IGURE CREENSHOT OF
The password is case sensitive with maximum length of 25 characters. The factory default password for
End User and administrator is "123" and "admin" respectively. Only administrator can get access to the
"ADVANCED SETTING" configuration page.
NOTE:
•
If you CAN NOT log into the configuration page by using default password, please check with the
VoIP service provider. Most likely the VoIP service provider has provisioned the device and
configured for you therefore the password has already been changed.
After a correct password is entered in the login screen, the embedded Web server inside the HT488 will
respond with the Configuration pages which are explained in details below.
T 7: HT488 D
ABLE EVICE
MAC Address
IP Address
Product Model
Software Version
System Uptime
Registered
PPPoE Link Up
NAT
Grandstream Networks, Inc.
C L -
ONFIGURATION OG IN
S P D
TATUS AGE EFINITIONS
The device ID, in HEX format.
troubleshooting.
This field shows IP address of the HT488.
This field contains the product model info, such as HT488.
Program: This is the main software release. This number is always used for
firmware upgrade. Current release is 1.0.3.86
Bootloader: current version is 1.1.0.1.
HTML: current version 1.0.3.86.
VOC: current version is 1.0.0.13
This shows system up time since last reboot.
Whether the unit is registered to service provider's server.
This shows whether the PPPoE is up if connected to DSL modem
This shows what kind NAT the HT386 is connected to. It is based on STUN
protocol. If the detected NAT is symmetric NAT, STUN will not work and
Outbound Proxy needed to make HT386 functioning correctly.
HT488 User Manual
Firmware 1.0.3.86
P
AGE
This is very important ID for ISP
Page 19 of 31
Last Updated: 7/2007