Data ( Psk ) Operation; Example Of Data Communications Device - Yaesu FT-991A Operating Manual

DATA ( PSK ) Operation

Example of Data Communications Device

Use commercial or free computer software for PSK data communications. See the illustration below for connecting the
FT-991A transceiver to a computer.
Be sure to read the instruction manual
Advice:
The FT-991A allows for PSK, Olivia, Contestia, etc. digital mode to be sent by the Data method or SSB. The conven-
tional method is to use USB, except RTTY, however the Data method allows for more accurate carrier frequency con-
trol, which is helpful in a Contest or DX environment.
DATA-AFSK
( PSK, OLIVIA, CONTESTIA, RTTY etc. )
FT-991A Settings
1. Press the MODE button, and then touch the corre-
sponding key on the LCD to select the USB operat-
ing mode. The "USB" icon appears in the display.
Advice:
USB is the conventional mode for AFSK transmis-
sion on all bands, however some users may be using
LSB.
F ( M-LIST )
2. Press the button to display the function
list.
[ MONI ]
3. Touch on the LCD. The Monitor function
will be set to "ON". The MULTI knob will function
as the MONITOR adjustment knob.
( SETUP )
4. Press the MENU
will appear in the display.
5. Rotate the MULTI knob to select Menu item "108
SSB PTT SELECT". Touch [ SELECT] on the LCD,
then rotate the MULTI knob to set this Menu item to
"RTS". Touch [ ENTER ] on the LCD.
6. Rotate the MULTI knob to select Menu item "109
SSB PORT SELECT". Touch [ SELECT ] on the
LCD, then rotate the MULTI knob to set this Menu
item to "USB". Touch [ ENTER ] on the LCD. Press
Page 122
of the interface device to be connected to the radio and computer.
RTTY/DATA JACK
DATA IN (Pin 1)
GND (Pin 2)
PTT (Pin 3)
SHIFT (Pin 4)
DATA OUT (Pin 5)
SQL (Pin 6)
Interface de-
vice commer-
cially available
Commercially available
USB cable
button. The Menu list
To LINE IN/MIC IN,
LINE OUT/MIC OUT,
COM port, etc.
To USB port
the MENU ( SETUP ) button or touch [ BACK ] on the
LCD to exit to normal operation.
Note:
All other SSB and DATA settings remain at their de-
fault.
Connect a USB Cable from the FT-991A USB
port and your computer
Advice:
Before connecting the USB cable you must down load
the SCU-17 Drivers. The Drivers can be found on the
FT-991A FILES page at the Yaesu Web page, www.
yaesu.com. Once the Drivers have been installed con-
nect the USB cable to the computer and then to the ra-
dio. At your computer's Device Manager you will find
a Standard Driver and Enhanced Driver installed.
Computer Settings
Soundcard
At your Computer Control Panel Sound set your
Speaker Audio default to USB AUDIO CODEC.
COM PORT
Check your Com Port assignments at your Computer's
Device Manager to be sure you have the Enhanced
and Standard Drivers. Make a note of the Com Port
numbers assigned.
FT- 991 Operating Manual