Daikin BRC3E52C Operation Manual page 15

Low
Medium-low
Auto
High
Medium-high
5
Characteristics of Cooling Operation
BRC2E52C7 / BRC3E52C7
4P368042-1 - 2014.02
Note
• The air conditioner may be in automatic fan speed control for
mechanical protection purposes.
• The air conditioner may be in automatic fan speed control
according to the room temperature.
Medium
• The fan may stop operating, which is not a failure.
• It may take time until fan speed changes are actually carried
out.
• In Auto mode, the fan speed is adjusted automatically
according to the setpoint and indoor temperature
• In case of Fan Only mode the fan speed is high.
• Depending on the type of indoor unit, there are two fan speeds
(low and high), three fan speeds (low, medium and high) or five
fan speeds available (low, medium-low, medium, medium-high,
high). Some indoor units also support automatic fan speed.
• When the ON/OFF button is pressed again, the air
conditioner will stop operating and the Operation
lamp will turn OFF.
Note
• When the system is stopped while in heating operation, the fan
will continue to operate for approximately 1 minute in order to
eliminate the residual heat in the indoor unit.
• To prevent water leakage or system failure, do not turn OFF the
power soon after the air conditioner stops operating. Be sure to
wait at least 5 minutes so that the drain pump finishes
discharging the residual water from the indoor unit.
• If the cooling operation is used when the room temperature is too low,
frost forms on the heat exchanger of the indoor unit which can
decrease the cooling capacity. In this case, the air conditioner
automatically switches to defrost operation for a while.
During defrost operation, a low airflow rate or a gentle wind is used to
prevent the discharge of melt water. (The remote controller displays the
fan speed that is set).
• When the outdoor air temperature is high, it takes some time until the
room temperature reaches the set temperature.
Basic Operation Method
Operation manual
14