Daikin BRC7EA628 Installation Manual
Wireless remote controller kit
Hide thumbs
Also See for BRC7EA628:
- Operation manual (20 pages) ,
- Operation manual (20 pages) ,
- Installation manual (16 pages)
Related Manuals for Daikin BRC7EA628
Summary of Contents for Daikin BRC7EA628
- Page 1 INSTALLATION MANUAL Wireless Remote Controller Kit MODELS BRC7EA628 BRC7EA629 BRC7EA630...
-
Page 2: Table Of Contents
BRC7EA628 Wireless Remote Controller Kit Installation manual BRC7EA629 BRC7EA630 CONTENTS SAFETY PRECAUTIONS............... 1 BEFORE INSTALLATION .............. 2 REMOTE CONTROLLER INSTALLATION ........2 RECEIVER INSTALLATION............3 FIELD SETTING ................8 TEST OPERATION ................ 9 Read these instructions carefully before installation. Keep this manual in a handy place for future reference. -
Page 3: Before Installation
2. BEFORE INSTALLATION 2-1 ACCESSORIES Check if the following accessories are included with your option kit. Receiver Wireless (3) Relay (4) Relay Name remote Screw (1) Light receiver (2) Transmission harness - long harness - short controller assembly PC-board Quantity 1 pc. -
Page 4: Receiver Installation
• Installing to a wall or a pillar 1. Fix the remote controller holder with the screws. 2. Slide the remote controller into the remote controller holder from the top. • How to insert the batteries ack cover 1. Open the back cover of the remote controller by sliding it in the direction of the arrow. - Page 5 2. Setting the address of wireless remote controller (It is factory set to “1”) Setting from the remote controller ON OFF 1. Hold down the button and the button TEST for at least 4 seconds to get the Field Set mode. TE P TI E (Indicated in the display area in the figure at right.)
- Page 6 (3) Attaching the receiver 1. Connect the included relay harness – long (3) and relay harness – short (4) to the connector on the transmission PC-board (2). onnect firmly to Transmission P -board (2) N1/X1A the connector. Relay harness – short (4) N2/X2A Relay harness –...
- Page 7 • Relay harness – short (4) to connector CN1/X1A on the light receiver assembly (1) After making these connection, clamp down relay harness – long (3) and relay harness – short (4) using the included clamp (7). BRC7EA628/29 Connector (X24A) (Black) Connect firmly to the connector.
- Page 8 (4) Attaching the control panel 1. Remove the sealing material and prepare new replacement sealing material (accessory). Inside view of the front grill Hook 3a Cover Hook 3b (pre-installed) Hook 2 Sealing Hook 4 material Hook 1 NOTE • The hook positions are the same for both pre-installed cover and control panel. 2.
-
Page 9: Field Setting
7. The control panel should be placed in the front grill as in the following figure. 8. Attach new sealing material in the original position (accessory (8)). 9. Attach the front grill and service cover to the indoor unit according to installation manual of the indoor unit. -
Page 10: Test Operation
ON/OFF input from outside (Set to enable starting/stopping Forced OFF input ON/OFF – from remote.) 12 (VRV system) Thermostat differential changeover (Set when using remote controller 1°C 0.5°C – thermostat sensor.) Air flow rate increase mode (to be Standard A little increase Increase set upon user’s request) NOTE... - Page 12 3P505117-2B 2020.10...