Table of Contents
Advertisement
3.1.7.
Basic Trap Configuration
Select "Basic Config" and "SNMP" and then "Basic Trap Configuration" to open the
screen shown in Figure 3-7. On this screen, you can configure the SNMP Trap set-
tings.
Screen Description
No.
Displays the entry number for the trap receiver.
Status
Displays the trap sending setting.
Enable
Disable
Type
Displays the type of traps.
v1
v2c
v2
IP Address
This is the IP address for the trap receiver.
IPv6 Address
This is the IPv6 address for the trap receiver.
Community
This is the community name used for trap sending.
Figure 3-7 Basic Trap Configuration
Sends traps.
Does not send traps. (Factory default setting)
Sends traps of SNMP v1. (Factory default setting)
Sends traps of SNMP v2c.
Sends traps of SNMP v3.
25
Advertisement
Table of Contents
