Hitron CGN01A User Manual page 109

4
If you are attempting to connect over the wireless network, there may be a
problem with the wireless connection. Connect via a LAN port instead.
5
If the above steps do not work, you need to reset the CGN. See
CGN on page 24. All user-configured data is lost, and the CGN is returned to its
default settings. If you previously backed-up a more recent version your CGN's
settings, you can now upload them to the CGN; see
page 52.
6
If the problem persists, contact your vendor.
Problem: I Cannot Access the Internet and the DS and US LEDs
Keep Blinking
Your service provider may have disabled your Internet access; check the Cable >
System Info screen's Network Access field (see
33).
Problem: I Cannot Connect My Wireless Device
1
Ensure that your wireless client device is functioning properly, and is configured
correctly. See the wireless client's documentation if unsure.
2
Ensure that the wireless client is within the CGN's radio coverage area. Bear in
mind that physical obstructions (walls, floors, trees, etc.) and electrical
interference (other radio transmitters, microwave ovens, etc) reduce your CGN's
signal quality and coverage area.
3
Ensure that the CGN and the wireless client are set to use the same wireless
mode and SSID (see
The Access Control Screen
4
Re-enter any security credentials (WEP keys, WPA(2)-PSK password, or WPS
PIN).
5
If you are using WPS's PBC (push-button configuration) feature, ensure that you
are pressing the button on the CGN and the button on the wireless client within 2
minutes of one another.
109 109
HITRON CGN USER'S GUIDE
The Setup Screen on page 86) and security settings (see
on page 93).
Version 2.0, February 2012. Copyright
Version 2.0, February 2012. Copyright
Resetting the
The Backup Screen
The System Info Screen
2012 Hitron Technologies
2012 Hitron Technologies
on
on page