Table of Contents
Advertisement
PRINTER CONTROLLER RW-470
Changes to the Controller RW-470 are possible and the manu-
facturer does provide separate information of them.
The technical specifications comply with
Installing the Controller into your PC
Note: The Printer Controller RW-470 is – like all other
high integrated circuits – sensitive to electrostatic
charge. Therefore, remove the controller carefully from
the shipping container and do only touch it at the side
or at the bracket. Do never touch any of the circuits on
the controller with your finger. If you need to do so,
touch a metal object before you touch the controller.
1. Switch off your PC before you install the controller.
2. Select a free PCI slot according specification above. Note
that on certain computers the PCI slot #5 is not fully com-
patible to PCI specification 2.0. In that case do not use slot
#5 and #6.
3. Insert the controller into the PCI slot and fasten the fixing
screw. Make sure the controller is sitting well, no compo-
nents touch surrounding cards or the case and that the fix-
ing screw is set properly.
4. Re-mount the PC case. Connect the cable(s) to the plotter.
Troubleshooting
The kernel driver will only run, if an controller board was found
and all self checks were passed successfully. To see, whether the
kernel driver is running: Run ControlPanel->Devices and check
whether the device „PRINTER CONTROLLER RW-470Drv" is run-
ning.
8
RW-470
Advertisement
Table of Contents
