Table of Contents
Advertisement
14
www.aeg.com
WARNING!
Do not push the knob for
more than 15 seconds. If the
oven burner does not light
after 15 seconds, release the
knob, turn it back to off
position and try to light the
oven burner again after
minimum 1 minute.
CAUTION!
In the absence of electricity
you can ignite the oven
burner without an electrical
device. In this case open the
oven door, put the flame
near the hole in the bottom
of the oven cavity, turn the
knob to the spark position
and push it down. Keep the
knob for the oven functions
pushed for equal or less than
15 seconds to let the
thermocouple warm up.
If the oven burner
accidentally goes out, turn
the knob for the oven
functions to the off position
and try to light the burner
again after minimum 1
minute.
Check if the burner holes are
not blocked.
8.4 Turning off the oven
burners
To put out the flame, turn the knob to
the off position.
8.5 Using the grill
1. Turn the knob for the oven functions
clockwise to
2. Adjust the deep pan runner position
to fit in different portions of food.
Refer to Grilling in "Hints and Tips"
chapter.
8.6 Cooling fan
When the oven operates, the cooling fan
turns on automatically to keep the
surfaces of the oven cool. If you turn off
the oven, the cooling fan can continues
to operate until the oven cools down.
If there is a defect in the
cooling fan, contact the
Authorised Service Centre.
8.7 Inserting the oven
accessories
Deep pan:
Do not use the deep pan on the first
shelf position in the main oven.
Push the deep pan between the guide
bars of the shelf support.
Wire shelf and the deep pan together:
Push the deep pan between the guide
bars of the shelf support and the wire
shelf on the guide bars above.
• All accessories have small
indentations at the top of
the right and left side to
increase safety. The
indentations are also anti-
tip devices.
• The high rim around the
shelf is a device which
prevents cookware from
slipping.
Advertisement
Table of Contents
